Elasto-Plastic Analysis of Tubular Joints of Offshore Platforms by Finite Element Method     

Chen Tieyun Zhu Zhenghong Professor  Dept. of Naval Architecture  Ocean Engineering  Shanghai Jiao Tong University  Shanghai Lecturer 《中国海洋工程》1991,(1)

The plastic node method is reformulated by the variational principle and is applied to elasto-plastic finite element analysis of tubular joints, eventually including the effect of internal and external gussets, stiffener rings, etc., if necessary. Four different joints are studied here in detail for the elasto-plastic behavior, the strain at the hot spot, the strain concentration factor around the intersection line, and the propagation of the plastic region with loading up to collapse in order to determine the ultimate strength, safety factor, and development of the plastic field. The present results are in good agreement with the experimental results.  相似文献   

Effect of Cyclic Loading Frequency on Undrained Behaviors of Undisturbed Marine Clay   总被引：2，自引：0，他引：2  

陈云敏  姬美秀黄博 《中国海洋工程》2004,18(4):643-651

Based on a series of cyclic triaxial tests, the effect of cyclic frequency on the undrained behaviors of undisturbed marine clay is investigated. For a given dynamic stress ratio, the accumulated pore water pressure and dynamic strain increase with the number of cycles. There exists a threshold value for beth the accumulated pore water pressure and dynamic strain, below which the effect of cyclic frequency is very small, but above which the accumulated pore water pressure and dynamic strain increase intensely with the decrease of cyclic frequency for a given number of cycles. The dynamic strength increases with the increase of cyclic frequency, whereas the effect of cyclic frequency on it gradually diminishes to zero when the number of cycles is large enough, and the dynamic strengths at different frequencies tend to the same limiting minimum dynamic strength. The test results demonstrate that the reasons for the frequency effect on the undrained soil behaviors are beth the creep effect induced by the loading rate and the decrease of sample effective confining pressure caused by the accumulated pore water pressure.  相似文献   

Estimation of Uplift Capacity of Rapidly Loaded Plate Anchors in Soft Clay     

S. P. Singh  D. P. Tripathy  S. V. Ramaswamy 《Marine Georesources & Geotechnology》2007,25(3):237-249

Plate anchors are extensively used in civil engineering constructions as they provide an economical alternative to gravity and other embedded anchors. The rate of loading is one of the important factors that affects the magnitude of soil resistance as well as soil suction force. This article outlines the effect of pullout rate on uplift behavior of plate anchors (70 mm diameter) buried in soft saturated clay by varying the pullout rate from 1.4 mm/min to 21.0 mm/min. The variation of breakout force and suction force with embedment depth and rate of pull are presented. A correlation between the rate of increase of undrained strength of clay and anchor capacity with rate of strain has been established. Finally an empirical equation has been proposed that includes the rate of pull in the estimation of breakout capacity of anchors.  相似文献   

Discussion: A review on the behaviour of helical piles as a potential offshore foundation system     

Shah Neyamat Ullah  Yuxia Hu 《Marine Georesources & Geotechnology》2020,38(9):1121-1127

Abstract

Helical piles have emerged as an attractive foundation system for offshore applications with renewed interest from the offshore community. Significant research gap currently exists in transferring this technology offshore and this paper discusses how existing and emerging knowledge can be successfully used to bridge some of the gaps. We focus on the Coupled Eulerian Lagrangian (CEL) large deformation finite element (LDFE) modelling technique that is commercially available and can be used to model the three-dimensional installation process with consideration of strain rate and softening effects in soft offshore clays. A helical pile of L?=?7.5?m long is modelled with one or two large-diameter helices (D?=?2?m) attached to a central shaft of d?=?0.5?m in diameter.The net effect of strain rate and softening is to increase the installation torque. The measured torque is within the range of 200–400?kN.m for the offshore clay and the pile geometry studied. Additional helices increase the uplift force but to a lesser degree than that of the measured torque. Remoulding induced strength reduction is found to be within the range of 25–33% of the intact clay strength. Issues of extracting and reusing offshore helical pile foundations are discussed.  相似文献   

Neotectonics of the Kharaulakh sector of the Laptev Shelf     

V.S. Imaev  L.P. Imaeva  O.P. Smekalin  A.V. Chipizubov  A.N. Ovsyuchenko  I.I. Kolodeznikov 《Russian Geology and Geophysics》2018,59(7):813-826

Seismotectonic deformation and crustal stress pattern have been studied comprehensively in major seismogenic structures of the Kharaulakh sector of the Verkhoyansk fold system and adjacent parts of the Chersky seismotectonic zone. The study focuses on neotectonic structures, deep structure, and systems of active faults, as well as tectonic stress fields inferred by tectonophysical analysis of Late Cenozoic faults and folds. The results, along with geological and geophysical data, reveal main strain directions and structural patterns of crustal stress and strain in the Arctic segment of the Eurasia-North America plate boundary. The area is a junction of mid-ocean and continental structures evolving in a mixed setting of extension, compression, and their various combinations. The rotation pole of the two plates is presumably located near Buor-Khaya Bay. In this case, extension is expected to act currently upon the neotectonic structures north of the bay and compression to control those in the south and southeast. This inference is consistent with the identified zoning of stress and strain in the Kharaulakh sector.  相似文献   

考虑应变局部化的粗粒料剪切损伤力学机制     

赵顺利  杨之俊  傅旭东  方正 《岩土力学》2023,44(1):31-42

针对粗粒料的应变软化、剪胀等力学特性,通过考虑以剪切带为标志的应变局部化现象,建立了具有广泛适用性的剪切损伤力学模型。损伤模型采用了包体理论中的剪切带数学简化,基于应变等价原理、Weibull分布,推导了粗粒料的应力-应变关系方程。从剪胀作用的机制出发,提出可以描述剪胀弱化的轴向塑性应变和体积塑性应变的非线性函数关系。结合粗粒料三轴压缩试验中的伺服过程,提出了基于遗传算法的损伤模型参数确定方法。通过开展不同围压下的粗粒料三轴压缩试验,对剪切损伤力学模型进行验证,进一步分析了参数演化对粗粒料强度和变形特征的影响。研究结果表明,考虑应变局部化特征的剪切损伤力学模型可以高精度的模拟粗粒料的应变软化和剪胀等特征,有效揭示剪切带内部变形对试样整体宏观变形的影响机制,模型中剪切带参数和围压的关系与粗粒料细观机制一致,计算得到强度组成与颗粒破碎、重组特征较为吻合。  相似文献   

考虑桩体刺入变形的透水混凝土桩复合地基固结理论研究     

韩柏林卢萌盟 《岩土力学》2023,(8):2360-2368

现有的多元复合地基利用两种或者两种以上的桩型对地基土进行加固,以期提高地基承载力、加速地基固结。提出了一种兼具散体材料桩和刚性不排水桩自身优点的透水混凝土桩复合地基固结模型。工程中刚性桩与土体的压缩量并不相等,这与等应变条件存在着不一致的地方。为此,抛弃传统等应变假设,考虑桩体向垫层和下卧层的刺入变形,对传统等应变假定进行修正,同时考虑了扰动区土体水平渗透系数的抛物线变化和水在桩体内的径向、竖向渗流,给出了此类固结问题的控制方程和解答以及复合地基固结度的表达式,并对复合地基固结度的解进行了讨论。最后与其他复合地基解做了比较并对固结性状进行了分析,并针对透水混凝土桩孔隙引起的桩阻作用对地基固结速度的影响进行了验证。  相似文献   

Neotectonic transpressional intraplate deformation in eastern Eurasia: Insights from active fault systems in the southeastern Korean Peninsula     

《地学前缘(英文版)》2023,14(4):101559

Transpression occurs in response to oblique convergence across a deformation zone in intraplate regions and plate boundaries. The Korean Peninsula is located at an intraplate region of the eastern Eurasian Plate and has been deformed under the ENE–WSW maximum horizontal compression since the late Pliocene. In this study, we analyzed short-term instrumental seismic (focal mechanism) and long-term paleoseismic (Quaternary fault outcrop) data to decipher the neotectonic crustal deformation pattern in the southeastern Korean Peninsula. Available (paleo-)seismic data acquired from an NNE–SSW trending deformation zone between the Yangsan and Ulleung fault zones indicate spatial partitioning of crustal deformation by NNW–SSE to NNE–SSW striking reverse faults and NNE–SSW striking strike-slip faults, supporting a strike-slip partitioned transpression model. The instantaneous and finite neotectonic strains, estimated from the focal mechanism and Quaternary outcrop data, respectively, show discrepancies in their axes, which can be attributed to the switching between extensional and intermediate axes of finite strain during the accumulation of wrench-dominated transpression. Notably, some major faults, including the Yangsan and Ulsan fault zones, are relatively misoriented to slip under the current stress condition but, paradoxically, have more (paleo-)seismic records indicating their role in accommodating the neotectonic transpressional strain. We propose that fluids, heat flow, and lithospheric structure are potential factors affecting the reactivation of the relatively misoriented major faults. Our findings provide insights into the accommodation pattern of strain associated with the neotectonic crustal extrusion in an intraplate region of the eastern Eurasian Plate in response to the collision of the Indian Plate and the subduction of the Pacific/Philippine Sea Plates.  相似文献   

描述饱和黏性土应变软化的弹塑性双面模型     

张涛  李涛  冯硕 《岩土力学》2022,43(10):2757-2767

常规三轴压缩试验中具有较强结构性的黏性土在围压较低时其应力−应变关系会呈现应变软化现象,一般还伴有塑性变形,通常土体内部结构损伤是应变软化产生的主要原因。考虑到采用经典塑性理论描述材料的应变软化不仅会违背 Drucker 的稳定性假设,而且也不能描述卸载塑性。因此,基于修正剑桥模型及 Li 和 Meissner 提出的塑性硬化准则,建立了一个描述饱和黏性土不排水应变软化的弹塑性双面模型。该模型以应力−应变曲线的峰值点分界,将应变硬化和应变软化分别作为独立的加载事件进行分析,同时引入新的结构性参数表征剪切过程中土体结构损伤导致的塑性刚度衰退。对不同固结状态饱和结构性黏土的三轴固结不排水压缩试验结果的模拟表明,所建模型能够较好地描述饱和黏性土的不排水应变软化特性。  相似文献   

基于数字图像分析的土工合成材料加筋砂土拉拔试验研究     

王家全  祁航翔  林志南  唐毅 《岩土力学》2022,43(12):3259-3269

由于加筋土界面作用的复杂性,加筋土工程建设中铺设土工格栅时往往采用经验的方法,很大程度上造成了土工格栅的浪费及工程安全隐患,理清不同填料筋土界面作用的影响范围,有助于确定加筋土结构的合理加筋间距。为了揭示不同填料筋土界面作用的影响范围,采用4种不同类型的砂土与格栅在不同法向应力下进行了一系列的拉拔试验,并结合数字图像量测技术,分析了不同类型砂土下界面剪切带厚度、颗粒位移矢量、格栅拉拔阻力峰值及应变等演变规律。研究表明：界面剪切带厚度H随法向应力σ_v与砂土平均粒径d₅₀的增加而增大,通过多变量拟合的方法,得到了H、σ_v与d₅₀三者之间的函数表达式;格栅在拉拔过程中,砂土颗粒位移矢量以土工格栅为界有着显著的差别,格栅上部的颗粒位移矢量明显大于下部颗粒,且在格栅上下一定范围内会形成颗粒位移矢量集中带;拉拔阻力峰值随σ_v及d₅₀的增加而增大;不同类型砂土各区段的格栅应变均表现出由前向后依次递减的趋势。  相似文献